Transfer Case - Misc

The TeraFlex 2Low 241-OR for TJ Wrangler Rubicon models will increase your standard low range shift pattern to include a rear 2WD low range option. The 2Low kit is a completely internal modification and does not require any other modifications to the transfer case housing or components. Installation can be done with the front-half of the transfer case remaining in the vehicle. This kit changes your shift pattern to include 2-Low: 2H - 4H - N - 2L - 4L Includes: Range Selector Shift Linkage... Read More Learn More

A shift linkage kit may be necessary to properly locate your transfer case linkage when a body lift is used on TJ Wranglers. Details: NP231 transfer case For use with body lifts or transfer case drops Welding required Learn More

Omix-ADA Transfer Case Shift Fork Pad For NP231 & NP242 For 1987-08 Jeep Models Transfer case shift fork pad, NP231 and NP242 transfer cases, 97-01 Cherokee, 99-04 Grand Cherokee, 02-07 Liberty, and 87-08 Wrangler. Direct OE replacement Jeep parts and accessories built to the original specifications by Omix-ADA. Limited five year manufacturer's warranty. Alternate Part # 4167969 Learn More

TRANSFER CASE DRIVE CHAIN NEW PROCESS 247, 1996-04 GRAND CHEROKEE Alternate Part # 5012322AB Learn More

DANA 20 TRANSFER case (1972-79 CJ), DANA 300 TRANSFER CASE (1980-86 CJ), PEUGEOT BA 10/5 5 SPEED 1987-89 WRANGLER & CHEROKEE, SR4 1980-81 CJ 4 SPEED, TREMEC T150 3 SPEED 1976-79 6 OR 8 CYL CJ5 & CJ7, TREMEC T176 & 177 4 SPEED 1980-86 CJ & SJ, WARNER T14 & T15 3 SPEED 1967-71 225 V6 CJ 1972-75 INLINE 6 CYL 232 CJ, WARNER T4 & T5 4 SPEED 1982-86 CJ; STABILIZER BUSHING (2 needed) Alternate Part # 945266 Learn More

For Jeeps 2007-2011 with 3.8L Engine and Automatic Transmission Only Learn More

The problem with the stock transfer case shifter linkage is that it attaches your shifter to the body and is then attached to the transfer case. It's a rather poor design from the start. Learn More

The 2Low kit increases trail turning ability by allowing tighter turns on narrow switchbacks, and eliminates most front end steering bind associated with 4WD. The 2Low kit is a completely internal modification and does not require any other modifications to the transfer case housing or components. Installation can be done with the front-half of the transfer case remaining in the vehicle. The 2Low retains the use of all factory low-range options such as, ESP disabling, electronic sway bar... Read More Learn More

This NP208 front or rear transfer case output shaft seal from Omix-ADA provides a defensive sealing surface to keep harmful contaminants out of the bearing while protecting against rust and corrosion Learn More