TeraFlex 3" Extreme Duty Outback Suspension System Without Shocks For 2007-18 Jeep Wrangler JK Unlimited 4 Door Models 1167204
The TeraFlex JK Outback suspension system is designed as a complete suspension system exclusively for expedition style overland travel. This kit was designed from the ground up for a dedicated vehicle capable of supporting sustained self-reliant travel over extreme terrain.
Legendary tracks such as the Canning Stock Route in Australia, or the Silk Road in China prove to be some of the toughest challenges a vehicle will ever face. This approach required TeraFlex to evaluate every component and verify the performance factor for each item. It was found that the majority of our products are by virtue of their original design perfectly suited for dedicated overland applications. Some components were modified to make them more suited for long stretches of washboard roads with no maintenance required. Some of these changes are found in the FlexArm joints - opting to use factory style rubber bushings at both ends of the flexarm. This delivers maximum vibration damping. The allowable flex provided by rubber bushings provides full articulation, utilizing maximum shock travel available. Special consideration and attention was spent on correct spring rate tuning and development.
Dedicated overland travel requires the use of specific spring rates suited to heavy loads and continuous mechanical resonance that react differently than ‘standard’ coil spring rates. This system incorporates custom load-enhanced heavy-duty spring rate coils to meet the performance demands of a fully loaded Jeep and maintain the lift height.
Suspension limiting straps prevent any potential damage to drivetrain or suspension by maximizing down travel safely. Additional details are addressed such as critical gusseting, bracing and other bracketry to beef up areas that are prone to damage and fatigue typically experienced with extended overland trips.
This kit will allow you to run up to a 35” tire (aftermarket wheels with 4.5” backspacing or less are required). Fits all JK Wrangler Unlimited models including Rubicon.
Fitment:Fits 2007-18 Jeep Wrangler Unlimited (JK)
Features:Alpine adjustable flexarms that feature maintenance-free bushings
Upgraded springs to maintain the lift height when loaded with heavy gear
Heavy-duty limit straps maximize down travel safety to prevent any potential damage to drivetrain/suspension
SpeedBump bump stops provide progressive compression during high-speed suspension movement
Heavy-duty adjustable front track bar and rear track bar bracket eliminates side-to-side movement
Warranty:Limited Lifetime Warranty
Parts Included:(2) Front Coil Springs
(2) Rear Coil Springs
(8) Adjustable Alpine Flexarms
(1) Adjustable Front Track Bar
(2) SpeedBump Bump Stops
Front Brake Line Anchor Kit
(2) Front Swaybar Disconnects
(1) Rear Track Bar Bracket
(2) Rear Swaybar Links
(4) Front Limit Straps
Coil Spring Retainers
Important Note: Because of the load enhanced spring rate, this kit is designed specifically for ‘heavy loaded’ Jeeps. A firmer ride will be experienced with an empty payload.
Driveshaft modifications are recommended with this suspension system. 2012-18 Jeep Wrangler JKs require exhaust spacers (#2610000) or other exhaust modification for proper driveshaft clearance.