Search results for: '16592.21'

2007-15 JK Wrangler and Rubicon 2-Door Double-Cardan joint Direct bolt on drive shaft Extended Length = 22.50" Compressed Length = 26.50" 1310 U-joints New original equipment JK Wranglers use drive shafts that have Rzeppa CV joints similar to most front wheel drive cars. These CV joints are fine for normal car applications but when you lift your Jeep or put on larger tires and drive your Jeep off road, these joints are not up to the task! Rugged Ridge has developed a solution for this... Read More Learn More

This steel CV rear driveshaft from Rugged Ridge helps to reduce vibration and the driveline angle Learn More

When you lift your Jeep or put on larger tires and drive off road, the factory driveshaft joints are not always up to the task! Rugged Ridge has developed a solution for this problem with double cardon Joint drive shafts for the JK Wrangler. Double U-joints provide better strength and operating angle and reduce vibration on lifted Jeeps. Each drive shaft has increased tube thickness and standard slip yokes for long life and easy of installation. Direct bolt on attaching to the stock axles... Read More Learn More

1987-93 YJ Wrangler Up to 3" lift 20" extended and 16" collapsed Measure from the outer edge of the seal on the original transfer case tailhousing to the center of the differential yoke u-joint. This measurement will be the center to center u-joint measurement for the new drive shaft and should be between 19 and 21 long. CV drive shafts are specifically made for NP231 slip yoke eliminator kits. Shafts are made using quality Dana Spicer components. Slip spline is coated to prevent... Read More Learn More