Auto Rust Technicians

Our SafeTCap ART-146 is a complete replacement for the original track bar and upper trailing arm bracket mounted on the rear axle. This mount was developed to fit a 2.75 diameter axle, but will work on larger diameter axles. The bracket straddles the sway bar bracket which remains in place during installation. The ART-146 is welded directly to the axle once the old bracket is removed and the surface to be welded is prepared. Our ART-146 bracket is made from 7 gage steel, and is CNC cut, bent,... Read More Learn More

Our ART-143 rear lower coil spring mount for the 1997-2006 Jeep Wrangler TJ/LJ was designed as a direct replacement for your original coil spring mount on the rear axle. This part is to be welded on the rear axle once the original spring mount is removed and the axle is ground down to clean metal. Our ART-143 is made from 7 gage steel and is CNC cut, bent and assembled by our AWS certified welders in the USA. This part is sold individually and is designed to fit both Driver and Passenger... Read More Learn More

Our SafeTCap ART-136 is a replacement for the OEM rear track bar bracket on the Jeep Wrangler TJ. The bracket is made from 7 gauge HRPO steel, CNC cut, bent and MIG welded in the USA facility. The hardware to remount the track bar is included with the bracket. To install this part you will need to disconnect the track bar and you simply cut off the old mount and weld the new mount in the footprint of the old mount. ATTENTION: The SafeTCap ART-136 is designed as an OEM replacement and is not... Read More Learn More

Auto Rust Full Center Frame With Rear Trail Arm Mount Repair Kit - Right Side 2003-06 Jeep Wrangler TJ/LJ Description: Our Safe-T-Cap frame repair kit is designed for a severely rusted frame on the TJ Wrangler. We have found that the frame starts to rust from the inside out, and can create an unsafe condition. Once the rust process starts, there isn't much that can be done except to cut the rust away, and then install our Safe-T-Cap repair kit. Product Details: Direct replacement ... Read More Learn More

Our SafeTCap® ART-135-1-R Front Frame Section was designed to cap over the passenger side original frame after removing the rotted metal, then welding the new frame repair section to the frame. Learn More

On YJs there is a factory body mount right above the frame at the forward rear leaf spring mounting point. The rubber bushing gets old and cracks, attracting moisture, dirt... and rust. Frame deterioration is a very common problem in this critical suspension mounting point. This unit includes the frame mount and the spring shackle mount. You will need to buy new leaf spring mount bushings for best results. This is a Safe-T-CapTM section that fixes the problem – we make it easy to... Read More Learn More

The CJ’s rear leaf spring mounting point has a factory rubber body mount above it that often leads to deterioration of the frame area. Over time, moisture gets trapped around the leaf spring bushings while dirt and debris get trapped inside the frame rails causing severe rust-through. Cut out the old mount and cut back the rust, then cover with the Safe-T-CapTM and weld in place – you’re back on the road without an expensive full frame replacement. You will need to buy new leaf spring... Read More Learn More

This part is for Right (passenger) side and Fits 1997-2006 Jeep Wrangler TJ. Our kit repairs the rear frame area that ties into the rear crossmember. It is designed to fit over your existing frame after you cut and remove the rotted portions. The part measures 24” long, is made from 11 gauge cold rolled steel, CNC cut and welded by our Certified welders. Learn More

Learn More

Learn More